- 2.00 LBS
- Calculated at Checkout
Experience Superior Air Quality with Our Smoke & Allergen-Removal Filter | NSpire Pro Replacement Filter
Looking for replacement H13 HEPA air filters for your NSpire Pro Premium Air Purifier system? We offer High-Efficiency HEPA composite ﬁlter screens and recommend you replace your HEPA filters after every 3000 hours (about every 125 days of continuous operation). Please note, both filters provided in this replacement set are required for each filter change.
As an added feature, the NSpire Pro Premium Air Purifier System will remind you when it’s time to replace your H13 HEPA filters (and clean the primary effect filter). When the machine runs to the given time, the indication lamp on the panel will light up, signaling that it’s time to replace your filter.
- Replacement H13 HEPA air filter effectively purifies particles, viruses, and bacteria in the air
- Removes odors and harmful gases
- Captures 99.97% of airborne particles
- Two (2) H13 HEPA filters
A reminder on overall filter maintenance for the NSpire PRO Premium Air Purifier system:
To replace the H13 HEPA air ﬁlter screen: Turn off the power and remove the plug from the socket. Open the rear cover and take off the primary effect ﬁlter screen. According to the panel replacement indication, take out the HEPA composite ﬁlter screen from the machine frame and put a new ﬁlter screen into the ﬁlter screen frame in sequence, then install the ﬁlter components back on the puriﬁer.
Primary effect ﬁlter screen: Under normal use, you should clean this filter every two to three months (cleaning frequency is decided by wind speed, air pollution degree and accumulative time). Please clean regularly, otherwise the efﬁciency of your NSpire PRO Premium will be affected. It’s convenient (and a good idea) to clean this filter when you’re replacing your H13 HEPA filter.
To clean the primary effect ﬁlter screen: Turn off the power, and remove the plug from the socket. Put your hand on the handle and pull outward at an angle, and lift up the rear cover and take it off the puriﬁer. Pull out the primary effect ﬁlter screen lightly by holding the two slides, and then pull up it, being careful not to not make dust ﬂy.
The dust can be removed by vacuum cleaner or brush, or be washed by water or detergent if it’s very dirty; install it back on the puriﬁer after it’s dried. (Don’t bend during the cleaning process to avoid damage.)
Install the ﬁlter components back on the product: ﬁrst put the HEPA composite ﬁlter screen, primary effect ﬁlter screen, front cover in corresponding positions and insert the inserted pieces into corresponding card slots, then shut the front cover. Connect the power and in ON status, press and hold the ﬁlter screen key for 5 seconds to reset.
- Filter Type: Medical Grade H13 HEPA Filter
- Quantity: 2 Filters